We use cookies to create the most secure and effective website possible for our customers, by using this website you agree to our use of cookies.
01387 270252reception@kosteruk.comKoster Aquatecnic Limited
Shower Tray Formers 

Shower Tray Formers

576db4053feea1c921b77b26

The Aquatecnic wet room shower tray formers are manufactured in the UK from 24mm thick birch ply and have a reputation for providing years of trouble free showering. They have been widely specified by architects in both large scale commercial and smaller domestic projects.

Benefits

  • 25 year guarantee
  • 24mm thick birch ply
  • Waste support
  • Stainless steel grating with membrane clamping plate (choice of six grating designs)
  • Fully trapped waste outlet (46 litres/min)
  • Slope to falls cut into tray to create a gradient of approximately 18mm between the perimeter of the tray and the waste.
  • Large choice of sizes
  • Made-to-measure options available

Waste Outlets

As standard the Aquatecnic Shower Tray Former is supplied with a high quality wet room waste outlet with an integral 50mm water trap. This trap is available with either a horizontal or vertical waste pipe attachment and has a drainage capacity of 46 litres per minute.

We can also offer untrapped gulleys for connection to a waste pump, wastes with a 60 litres per minute flow rate, Caroflow Lo-line traps (only 95mm deep) and wastes with a 75mm water trap. ( see Wet Room Drainage ).

Custom Made Shower Tray Formers

With our made-to-measure service you can order the precise shape and size of shower tray former you need. Simply send us your drawing showing overall dimension, waste centre position (min.300mm from edge) and any flat areas or out of square angles required.

We offer a full and free advice service in relation to planning your wetroom tray,so please contact us on 01387 270252 at an early stage for further guidance on the ideal specification for your project.

To Purchase

  • Choose the size of tray former you require (dimensions are given and a diagram will appear to show waste positioning on selected former).

  • Select between vinyl or tiled floors and the relevant grating options will appear below.

  • Finally select either a horizontal or vertical waste outlet.

    Note: For made-to-measure formers, please input the dimensions required in mm (taking care not to exceed the maximum sq.m size selected). Choose either the centred or off-centre waste option. For the off-centre waste you will need to send us, by fax, email or post, a brief sketch clearly showing the exact centre point of waste required (no closer than 300mm to any edge). You can then continue by selecting tileset and waste options, as with the standard formers. If you have any questions please contact us prior to ordering.

Size

Floor Finish

Waste Outlet